 |
| 6oz fiberglass cloth taped into place. I hadnt noticed the cloth had shifted before I cut it at the bow. |
 |
| I left enough extraneous area to make it easy to cut the cloth after the side was soaked with epoxy. |
 |
| Ive found that its much easier to remove the tape by pulling it AWAY from the fiberglass cloths frayed edge than toward it. MUCH less hassle. |
center;">
Cloth wetted out with epoxy resin & trimmed along the bottom.
I have also cut and assembled the transom knee for the Zip. I dont have photos at the moment, so more on that later....
Cloth wetted out with epoxy resin & trimmed along the bottom. |
| Because I hadnt noticed that the cloth shifted earlier, I cut away too much around the bow, and did not have enough cloth to lap over onto the port side. |
 |
| I mis-judged and mixed WAY too much epoxy, so I went ahead and fiberglassed part of the port side using the scrap cloth cut from the bow area. |
0 komentar:
Posting Komentar