4th of July in the boat shop

It was a busy 4th of July weekend in my cramped little boat shop. I set out my U.S. Yacht Ensign flag, and got right to work.

After a week of shaping that mahogany shim on the port chine, I finally got it to a point I was satisfied with. So, without any more delays, I epoxied on the forward bottom planking.

The shim on the port chine

3/4 of the bottom planking is now attached.

This time around, I used System Three Silvertip epoxy, thickened with the remainder of my collected mahogany sawdust. I learned a valuable lesson about using thickened epoxy versus Gel Magic.

Although I used the remainder of my mahogany sawdust, the mixture was still not as viscous as Gel Magic. However, it sure seemed thick enough to do the job. In the end, I used perhaps 2/3 as much epoxy for the port side as Id used of GelMagic when I did the starboard. Not only that, but it was easier and faster to apply. This saved me time, stress, and money.... some pretty good selling points. 

I still had plenty... PLENTY... of squeeze-out to fill the gaps I was concerned about, too.

I also used 4” spacing on the screws for this side, compared to the 3” spacing I used on the starboard side. The planking contact seemed just as good, and I used 3/4 as many screws (73 this time, compared to 97 before). Again, this saved me time, stress and money.

And yes, this time I did remember to scrape away excess epoxy from the areas where I’ll need to fit the butt blocks.

Related Posts by Categories