Outside in the garage, I finished laying out the forward bottom panel. Will cut tomorrow and splice into the other bottom panels. Scarf will be 2" for an 8:1 scarf. Pretty simple. tough part will be cleaning the garage to make the second scarf joint.
src="https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEg4X0DsaQVB3aPshAWUSWDtDMkQWxqjANx8UR8v70vZCDAIQK9VZwvBkzljtblEYBbt6HsOp0y5GkfHV2vgmrnv-vDwRsQ_1pWsaCc_l6JRAttJv94NaZpeCCIlqLf13oj5znQsWos6a24/s640/blogger-image-753793691.jpg">


When I took this off the "press" both corners did not seat well. It took a few minutes with a belt sander and then a follow up with a little fairing compound to get a nice smooth filet. Front side was fine. Back side a little messy. On the second attempt, I clamped the mahogany board down on each end and already see an improvement. Nothing a little filler cant fix. The second panel yielded the same results. I believe that my mahogany clamp is not flexible enough to get good pressure on the edges.


Forward panel is scribed and ready to cut.
0 komentar:
Posting Komentar